Linkage for OTB Sling Shot intake

How about this new Stromberg linkage for the OTB Sling Shot intake? Or any other crazy 2×2 side-by-side carburetor application come to that – like the Frenzel flathead supercharger. In fact we have supplied a couple of made-to-order kits for those. But this is an off-the-shelf kit that will accommodate spacing of up to 6-11/16in. Kit 9263-D.

These are the highlights.

  • Complete 2×2 non-progressive linkage for ‘side-by-side’ carburetor applications
  • Unique low-line stainless steel brackets support the Back-bar shaft at four points for zero flex and positive operation. Oilite self-lubricating bushes and two small washers to take up any height difference in the base castings.
  • Stainless steel Back-bar shaft with two end stops to prevent lateral movement.
  • Two stainless steel links from the Back-bar levers with Stromberg Linkage Bomb clips (9564K-R) for attachment to the carburetors.
  • One Stromberg 9096K long lever, which can be positioned anywhere along the Back-bar shaft to align with your throttle pedal ‘pull’ point. Complete with swivel and clamping screw.
  • Easy to fit. Supplied part-assembled, with instructions!

Want to see the linkage in action? This was an earlier model, but the principle is the same. Twin-plug flathead motor built by Austin Speed Shop and Keith Tardel for our buddy Doc from Louisiana.

Check it out on the Stromberg website right here …

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.